ELIMFILTERSNANOFORCE™ · EH6SPIN-ONELIMFILTERSNANOFORCE™ · EH6CARTRIDGE
Particles held on each filter's pleated mediaLeft: spin-on (replaced whole) · right: cartridge in a housing (only the element is replaced)The two NANOFORCE™ filter formats compared. In the spin-on, the pleated media comes inside its own sealed can: at service the whole unit is unscrewed and replaced. In the cartridge, the housing is a permanent part of the equipment: at service the bowl comes off, only the element is changed and the same bowl is refitted. In both, the hydraulic fluid passes through the pleated media, which holds the particles. Illustrative simulation of how it works: a conceptual animation, not an engineering model or test result, and it shows no product data.

How to read this figure

  1. Heads on the bracket. Both filters hang from a fixed head with an inlet and an outlet port. The head belongs to the equipment and is never replaced at service.
  2. Left: spin-on. The pleated NANOFORCE™ element is sealed inside its own can, which screws onto the head.
  3. Right: cartridge. A permanent bowl closes against the head and holds a pleated NANOFORCE™ element that is replaced on its own.
  4. Flow. In both formats the fluid enters through the head, crosses the pleated media, where the particles are held, and leaves through the head toward the circuit. The filtration principle is the same.
  5. Service. Moving the cursor to the top, or pressing E, runs the service: the spin-on comes off whole, can included; on the cartridge the bowl drops, the element is changed and the same bowl goes back.